Troubleshooting

Garage Door Won't Close? Sensors, Tracks and Opener Fixes

A garage door that won't close, or reverses as soon as it gets near the floor, is almost always reacting to its safety sensors; clean and realign them first, then check the tracks and the opener's close-limit and force settings.

Updated October 2026Door won't open or close

Start with the safety sensors

The two small "photo eyes" on each side of the door, no more than six inches above the floor, stop the door if anything crosses the beam. Most openers flash their light or won't close when the beam is broken.

  1. Remove anything in the beam's path (boxes, leaves, a bike)
  2. Wipe both lenses
  3. Check that both indicator lights are steady; a blinking or dark light means misalignment
  4. Loosen the bracket, aim the sensors at each other until the light is steady, then tighten
  5. Look for a cut or chewed wire

Never bypass or tape over the sensors: they are a required safety feature.

Advertisement

Then look at the tracks and rollers

A bent track, a roller out of place or a loose bracket can make the door hit resistance, and the opener reverses. If the door is crooked or a cable is loose, stop and call a technician (off-track repair).

Opener settings

If the door reverses right after touching the floor, the close-limit or force setting may need a small adjustment (see the opener manual). Test after any change: the door must reverse when it touches a 1½-inch object (a flat 2×4) on the floor.

Advertisement

If the door is stuck open

Most openers let you close the door by holding the wall button down until it reaches the floor (this bypasses the sensors only while you hold it, and you can see the door). If that doesn't work and the garage can't be left open, see emergency garage door repair.

Typical costs

Prices garage door companies publish

Middle half (25th–75th percentile) of the prices on companies' own websites, October 2026; dot = median.

Advertisement

Common questions

Why does my garage door go back up when I try to close it?

Usually the safety sensors are blocked, dirty or misaligned. Less often it's the close-force setting or something on the track.

How do I close my garage door if the sensors don't work?

Press and hold the wall button until the door is fully down. If it still reverses, call a technician rather than disabling the sensors.

Related guides